Sierra Wireless AceView User's Guide Page 17

  • Download
  • Add to my manuals
  • Print
  • Page
    / 53
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 16
Introduction to the AirLink Raven XE
Rev 3.0 Feb.12 17
UMTS
UMTS (Universal Mobile Telecommunications System) supports data transfer
rates of up to 1920 kbit/s; most users can expect performance up to 384 kbit/s. A
UMTS network uses a pair of 5 MHz channels: one in the 1900 MHz range for
uplink, and one in the 2100 MHx range for downlink.
EDGE
EDGE (Enhanced Data rates for GSM Evolution) provides end-to-end packet data
services with an enhanced connectivity building on GPRS technology and using
the established GSM networks. EDGE provides higher transmission rates and
better transmission quality for data than GPRS. EDGE can carry data at speeds
typically up to 384 kbit/s in packet mode.
When EDGE is not available, your AirLink Raven XE will fall-back to GPRS for the
connection to Sprint to provide continued connectivity.
GPRS
General Packet Radio Service (GPRS) is packet-switched with many users
sharing the same tranmission channel, but only transmitting when they have data
to send. This means that the total available bandwidth can be immediately
dedicated to those users who are actually sending at any given moment,
providing higher use where users only send or receive data intermittenly. GPRS
provides speeds of 30 - 70 kbps with bursts up to 170 kbps.
Connection Methods
You can connect the AirLink Raven XE to a USB or an Ethernet (RJ45) port on a
computer. When connected to a USB or Ethernet port, the AirLink Raven XE
behaves like a network card.
USB Port
The AirLink Raven XE is equipped with a USB port which increases the methods
by which you can send and receive data. The USB port can be set to work as
either a virtual Ethernet port or a virtual serial port. A driver installation is required
to use the USB port in either mode. USB drivers can be downloaded from the
Sierra Wireless AirLink Solutions web site: http://www.sierrawireless.com/support.
It is recommended that you use a USB 2.0 cable with your AirLink Raven XE and
connect directly to your computer for best throughput.
Virtual Serial Port
The AirLink Raven XE supports one virtual serial port over USB. This VSP can be
used, for example, to send AT commands, or to run many serial based
applications such as HyperTerminal
®
.
Page view 16
1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 52 53

Comments to this Manuals

No comments