Sierra Wireless WISMO218 User Manual download pdf (Page 10)

WA_DEV_W228_UGD_002 Rev 003 Page 10 of 78

WISMO228 TCP/IP AT Commands

Manual

Information Responses and Result Codes

Responses start and end with <CR><LF>, except for the ATV0 DCE response format and the ATQ1

(result code suppression) commands.

 If the command syntax is incorrect, the "ERROR" string is returned.

 If the command syntax is correct but transmitted with the wrong parameters, the "+CME

ERROR: <Err>" or "+CMS ERROR: <SmsErr>" strings are returned with adequate error codes

if CMEE was previously set to 1. By default, CMEE is set to 0, and the error message is only

"ERROR".

 If the command line has been executed successfully, an "OK" string is returned.

In some cases, such as "AT+CPIN?" or (unsolicited) incoming events, the product does not return the

"OK" string as a response.

In the following examples, <CR> and <CR><LF> are intentionally omitted.

Logos

This picture indicates the +WIND indication from which the AT command is allowed. X

values can be: 1, 3, 4, 16.

This picture indicates that a SIM card must be inserted to support the AT command.

This picture indicates that an AT command is supported even if the SIM card is absent.

This picture indicates that the PIN 1/CHV 1 code must be entered to support the AT

command.

This picture indicates that an AT command is supported even if the PIN 1/CHV 1 code is

not entered.

This picture indicates that the PIN 2/CHV 2 code must be entered to support the AT

command.

This picture indicates that an AT command is supported even if the PIN 2/CHV 2 code is

not entered.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 78 79

No comments

Sierra Wireless WISMO218 User Manual Page 10