Sierra Wireless WISMO218 User Manual download pdf (Page 27)

WA_DEV_W228_UGD_002 Rev 003 Page 27 of 78

WISMO228 TCP/IP AT Commands

Manual

Command

Responses

AT+WIPBR=3,5,16

Note: Read the destination IP address for GSM bearer

+WIPBR: 5,16,”0.0.0.0”

Note: Destination IP address is not set as GSM bearer is still not

connected

AT+WIPBR=4,5,0

Note: Start the GSM bearer as a client

AT+WIPBR=3,5,15

Note: Read the local IP for GSM bearer

+WIPBR: 5,15,”1.1.1.1”

AT+WIPBR=3,5,16

Note: Read the destination IP for GSM bearer

+WIPBR: 5,16,”2.2.2.2”

AT+WIPBR=5,5

Note: Stop the GSM bearer

AT+WIPBR=0,5

Note: Close the GSM bearer

Notes

For Starting a Bearer

The mandatory parameters to start a bearer in

 client mode are: <cmdtype>, <bid> and <mode>

Depending on the mode and the bearer type, additional parameters are required or forbidden:

Bid

Mode

Other Parameters

None

For Opening a Bearer

Opening a bearer only consists of associating the IP protocol stack with the specified bearer. The

corresponding bearer setup has to be done through the already existing AT commands.

Several bearers can be opened at the same time but only one bearer can be started at a time.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 78 79

No comments

Sierra Wireless WISMO218 User Manual Page 27