WA_DEV_W228_UGD_002 Rev 003 Page 46 of 78
WISMO228 TCP/IP AT Commands
Manual
UDP socket: a non escaped [ETX] signals the boundary of the current received datagram.
TCP socket: a non escaped [ETX] signals that the peer TCP connected to the TCP unit has
shutdown (through the downlink way). Desktop PC1 should then close the uplink socket to
IP Network (active socket)
Data containing a [DLE][ETX] sequence.
Data containing an [ETX].
Mark the boundary of the UDP Datagram
received/to be transmitted.
Data containing a [DLE][ETX] sequence.
Data containing an [ETX].
Causes/signals a shutdown operation on TCP
socket.
Note: The behaviour is symmetrical in the sense that it applies both on the transmitting and the receiving side
of the UART.
[DLE] Escaping Mechanism
A [DLE] character will be sent as data only when it is preceded by another [DLE] character. A single
[DLE] character which is not preceded by a [DLE] character will not be transmitted.
Comments to this Manuals