Sierra Wireless WISMO218 User Manual download pdf (Page 52)

WA_DEV_W228_UGD_002 Rev 003 Page 52 of 78

WISMO228 TCP/IP AT Commands

Manual

Command

Responses

AT+WIPDATA=2,5,1,20,10

Note: TCP with index 5 can send/read data in continuous

mode with <send size> set to 20 and <wait time> set to

CONNECT

+++

Note: +++ sequence causes the UART to switch to AT mode

AT+WIPDATA=2,5,2,10,5

Note: TCP with index 5 can send/read data in continuous

transparent mode with <send size> set to 10 and <wait

time> set to 5

CONNECT

+++

Note: +++ sequence causes the UART to switch to AT mode

AT+WIPDATA=2,5,2

Note: TCP with index 5 can send/read data in continuous

transparent mode

CONNECT

+++

Note: +++ sequence causes the UART to switch to AT mode

Notes

Continuous Mode (Non-Transparent) for a TCP Mapped Socket

If the [ETX] character is sent from the peer, it is considered as an end of data transfer. After sending

an [ETX] character, the socket will be shutdown and the peer will be informed of this shutdown by a



This indicates that no more data can be sent from the host socket, but it can receive data. The

schematic below shows the shutdown procedure for a TCP socket:

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 78 79

No comments

Sierra Wireless WISMO218 User Manual Page 52